Airlink101 802.11g Wireless Router AR315W - Manual (Page 9)

Section 4
Connecting to the Router Wirelessly
Below are the default wireless settings of the router. You must configure your wireless network card to the
same settings in order to establish a wireless connection with the router. Please refer to your wireless
network card’s manual for configuring these settings.
SSID: default
Operating Mode: Infrastructure
Channel #: 11
WEP: disabled
You may need to restart your computer after establishing a signal strength/link quality with the router.
Step 1 Power off the Cable/DSL modem, router, and computer and wait for 5 minutes.
Step 2 Turn on the Cable/DSL modem and wait for the lights on the modem to settle down.
Step 3 Turn on the router and wait for the lights on the router to settle down.
Step 4 Turn on the computer.
Step 5 Redo the Setup Wizard.
Step 6 Verify the Internet Connection Test is successful.
Section 5
Troubleshooting
If the Internet Connection Test fails, try the following steps:
If you can ping the router but cannot access the router’s web configuration page, try the
following steps:
For Windows 9x/ME/2000
Step 1 Go to Start, Settings, Control Panel, Internet Options.
Step 2 Select the Connections tab and click the Setup button.
Step 3 Select “I want to set up my Internet connection manually, or I want to connect through a
local area network (LAN)” and click Next.
Step 4 Select “I connect through a local area network (LAN)” and click Next.