Avocent SwitchView - Manual (Page 12)

SwitchView
User Manual
Key Sequence Action
Addr Selects an active channel via keyboard.
Dnn Configures the dwell time. Substitute nn with
a value from 2 to 60 seconds.
SG Enables the scan Go command.
SH Enables the scan Halt command.
M+ Mouse will suspend scanning.
M- Mouse will not suspend scanning. (default)
MR If you hot-plug the SwitchView to a PC con-
nection you may experience a loss of mouse
signal. Use this command to restore the signal
if you’re using a PC with a standard PS/2
mouse driver. (See page 8)
MW Use this command to restore the mouse signal
if you’re using a PC with a Microsoft Intel-
liMouse driver. (See page 8)
Kn Sets keyboard scan set; n is a number 1 - 3.
AV Displays the current firmware version of the
SwitchView processors. You must be at a DOS
prompt or in a text editor/word processor to
view this information.
H1 Default Command Mode Activation
H2 Changes the Command mode activation
sequence to
H3 Changes the Command mode activation
sequence to
H4 Changes the Command mode activation
sequence to <->
ZM Used to resynchronize the mouse after a hot-
plug. Repeat, if necessary, until synchroniza-
tion is re-established.
NOTE: Using this command while the mouse
is operating correctly will cause the mouse
to lose sync.
Appendix
The following is a summary of all operational commands.
10