Samsung UE40D7000LS - Manual (Page 7)

English - 7
Plug & Play (Initial Setup)
When the TV is initially powered on, a sequence of on-screen prompts will assist in configuring basic settings.
Press the
POWER P button. Plug & Play is available only when the Source is set to TV.
✎
Before turning on the TV, make sure the antenna cable is connected (p. 6).
1
Selecting the OSD
Language Press the ▲ or ▼ button, then press the ENTER E button.
Select the desired OSD (On Screen Display) language.
2
Setting up the Network Set up your network connection. Press the ENTER E button to start. If you do
not know your network set up information or want to set to it later, select Skip.
We suggest you skip network connection setup now and refer to “Network
menu” in the e-Manual for set up requirements and instructions, and the
Network Connection section of this manual (p. 13).
You can set up the network connection later using the Network menu.
3
Software Upgrade Select Next to upgrade TV software. Your TV will automatically upgrade, if your
TV need a software upgrade. If you want to upgrade later, select the Skip. For
more information, refer to “Software Upgrade” (Preference Features
→ Support
Menu) in the e-Manual.
✎ This may take some time, depending on network status.
4
Selecting the usage
mode Press the ▲ or ▼ button to select Home Use, and then press the ENTER E
button twice.
✎ Select the Home Use mode. Store Demo mode is for retail environments.
5
Select Country
(Depending on the
country) Press the ▲ or ▼ button, then press the ENTER E button. Select the
appropriate country.
✎ After selecting the country in the Country menu, some models may
proceed with an additional option to setup the pin number.
✎ When you input the PIN number, 0-0-0-0 is not available.
6
Setting the Clock
Mode Set the Clock Mode automatically or manually.
Auto: Select the time zone where you are located.
Manual: Allows you to manually set the current date and time.
7
Selecting search
options for auto tuning Press the ▲ or ▼ button, then press the ENTER E button. Select the channel
source to memorise. When setting the antenna source to Cable, a step appears
allowing you to assign numerical values (channel frequencies) to the channels.
For more information, refer to Channel
→ Auto Tuning.
✎ When Air or Cable is selected first: After all Air or Cable channels are
stored, the step for storing Satellite channels is displayed.
✎ When Satellite is selected first: After all Satellite channels are stored, the
step for storing Air or Cable channels is displayed.
✎ Press the ENTER E button at any time to interrupt the memorisation
process.
8
Enjoy your TV. If you want to watch a broadcast Programme, select Close. If you want to enjoy
the Smart Hub, select the Smart Hub. The Smart Hub will start. For more
detailed information, refer to “Smart Hub” in the e-Manual.
If You Want to Reset This Feature...
You should do Plug & Play ( MENU → System) again at home although you did in shop.
Select System - Plug & Play (Initial Setup). Enter your 4 digit PIN number. The default PIN number is “0-0-0-0”
(except France). If you want to change the PIN number, use the Change PIN function.
✎
If you forget the PIN code, press the remote control buttons in the following sequence in Standby mode,
which resets the PIN to “0-0-0-0” (France: “1-1-1-1”):
POWER (off) → MUTE → 8 → 2 → 4 → POWER (on).
[UD7000-ZF]BN68-03438G-03L04.indb 7 2011-04-21 오전 9:11:23