Alpine cda-9825 - Manual (Page 7)

5
-EN
Basic Operation
SOURCE/POWER
Detaching the Front Panel
1
Press and hold the SOURCE/POWER button for more
than 3 seconds to turn off the power.
2
Press the (Release) button at lower left side until
the front panel pops out.
3
Grasp the left side of the front panel and pull it out.
NOTES
• The front panel may become hot in normal usage (especially
the connector terminals on the back of the front panel.) This is
not a malfunction.
• To protect the front panel, place it in the supplied carrying
case.
Attaching the Front Panel
1
First, insert the right side of the front panel into the
main unit. Align the groove on the front panel with the
projections on the main unit.
2
Push the left side of the front panel until it locks firmly
into the main unit.
NOTES
• Before attaching the front panel, make sure that there is no
dirt or dust on the connector terminals and no foreign object
between the front panel and the main unit.
• Attach the front panel carefully. Hold the panel by its sides to
avoid pushing any buttons by mistake.
2
1 1
Remote Controllable (CDA-9826 only)
This unit can be controlled with an optional Alpine
remote control. For details, consult your Alpine dealer.
Initial System Start-Up
Be sure to press the RESET switch when using the unit
for the first time, after installing the CD changer, etc., or
after changing the car battery.
To do this, first, remove the detachable front panel. Behind
the front panel, to the right of the connector, there is a small
hole. Using a ball-point pen or other pointed object, press
the RESET switch mounted behind this hole to complete
the initialization procedure.
Turning Power On and Off
1
Press the SOURCE/POWER button to turn on the unit.
NOTE
The unit can be turned on by pressing any other button except
the eject c and DISP/TITLE
button.
Press and hold the SOURCE/POWER button for at
least 3 seconds to turn off the unit.
NOTE
The first time power is turned on, the volume will start from level
12.
About the alphanumeric display of this unit
• All English lower case characters are displayed as
upper case on this unit.
• The alphanumeric display in the following table shows
alphanumeric characters/numbers that may be difficult
to distinguish.
0 2 5 6 8 A B D
G H K M Q R S Z
Alphanumeric
Alphanumeric
Display
Display
1
RESET switch