AOC FT710 - Manual (Page 7)

INSTALLATION INSTRUCTIONS
SWIVEL BASE
To attach the swivel base to the monitor, do the following:
• Carefully turn the monitor on its side or upside down.
(see figure 1)
• Locate the cavities at the bottom front of the monitor.
• Insert the pegs on the swivel base into these cavities. Push the swivel base forward
until the swivel base locks in place.
• To remove the swivel base, hold the bottom of the swivel base, then push it out.
POWER CORD
Power Source:
1. Make sure the power cord is the correct type that required in your area.
2. This monitor has a universal power supply that allows operation in either 100/120V
AC or 220/240V AC voltage area (No user adjustment is required).
3. Connect the power cord into your monitor’s power input socket, and then plug the
other end into a 3-pin AC power outlet. The power cord may be connected to either
a wall power outlet or the power outlet socket on your PC, depending on the type of
power cord supplied with your monitor.
VIDEO CABLE
Connecting the Video Cable: the monitor comes with a built-in video cable. Plug
the signal cable
′s 15-pin connector into the computer's video port and tighten the two
screws on the cable connector. (see figure 2)
Caution: Don’t bend the signal cable, otherwise it will break the inner wire.
Connecting the Power Cord: Plug the power cord into the monitor's AC power
socket. Then plug the power cord into a grounded AC outlet or UL-approved power
strip or the power output socket on your PC.
Caution: If the AC outlet is not grounded, install the proper grounding adapter
(not supplied).