Nilfisk-ALTO 3DS - Manual (Page 3)

AMERICAN SANDERS TECHNOLOGY Operator’s Manual - 3DS Page 3
DANGER means: Severe bodily injury or death can or will occur to you or other personnel if
the DANGER statements found on this machine or in this Operator's Manual
are ignored or are not adhered to. Read and observe all DANGER state-
ments found in this Operator's Manual and on your machine.
WARNING means: Severe injury can occur to you or to other personnel if the WARNING
statements found on your machine or in this Operator's Manual are ignored
or are not adhered to. Read and observe all WARNING statements found in
this Operator's Manual and on your machine.
CAUTION means: Minor personnal injury, property damage, or damage to machine can occur if
the CAUTION statements found on your machine or in this Owner's Manual
are ignored or are not adhered to. Read and observe all CAUTION state-
ments found in this Operator's Manual and on your machine.
DANGER: Failure to read the Operator's Manual prior to operating or servicing your machine could
result in injury to you or to other personnel; damage to the machine or to other property could
occur as well. You must have training in the operation of this machine before using it. If you
cannot read English, have this manual explained fully before attempting to operate
this machine.
DANGER: Operating a machine that is not completely or fully assembled can result in injury to the
operator or property damage. Do not operate this machine until it is completely assembled.
Keep all fasteners tight. Keep adjustments according to machine specifications.
DANGER: Explosive materials, severe bodily injury or death can occur. Sanding/finishing wood floors
can create an explosive or combustible environment. Do not operate this machine around
solvents, thinners, alcohol, fuels, floor finishes, wood dust or any other flammable materials.
Vapors and wood dust generated by sanding or finishing wood flooring can create an
explosive environment. Cigarette lighters, pilot lights, electrical sparks and all other sources
of ignition should be extinguished or avoided. Keep work area
well ventilated.
DANGER: Dust generated from sanding wood floors can spontaneously ignite or explode. Promptly
dispose of any sanding dust in a metal container clear of any combustibles. Do not dispose
in a fire.
DANGER: Electrocution could occur if the machine is being serviced while the machine is connected
to a power source. Disconnect the power supply before servicing. Always remove the
electrical plug from the power source before changing the brush pad or other attachment.
Always disconnect the power supply before leaving the machine.
DANGER: Electrocution or fire could occur if the machine is being operated with a damaged power
cord. Keep the power cord clear of the pad. Always lift the cord over the machine. Do not
move the machine by the power cord.
DANGER: Electrocution could occur if the machine is used on an ungrounded electrical circuit. Always
use a three-wire electrical system connected to the electrial ground. Never remove or
disable the grounding supply conductor on the electrical cord. Consult an electrician if the
grounding conductor is missingf or if you suspect your circuit is not grounded properly.
WARNING: Always use a three-wire electrical system connected to the electrical ground. For maximum
protection against electric shock, use a circuit that is protected by a ground fault interrupter.
Consult your electrical contractor.
WARNING AVERTISSEMENT ADVERTENCIA
OPERATOR SAFETY INSTRUCTIONS