Installing the drivers – Adaptec AVC-2210 User Manual
Page 14
6
VideOh! DVD AVC-2210 User’s Guide
3
Turn on your computer if you haven’t already done so, then
connect the AVC-2210 to your computer using the provided
USB 2.0 cable.
4
Insert the VideOh! Installation CD into your CD-ROM drive.
5
Turn on the AVC-2210 by pressing the Power button. The LED
on the front of the AVC-2210 will light up orange when first
powered on.
Note:
If the VideOh! DVD Software Installation screen
appears, exit this screen until driver installation is
complete.
Now you are ready to install the device drivers.
Installing the Drivers
Before you can begin capturing video, you must install the VideOh!
DVD device drivers.
Installation is an easy two-step process. First you install the USB
loader, then you install the device driver. Follow the complete set
of installation instructions provided for your operating system to
ensure that the driver is properly installed :
■
For Windows XP, see
■
For Windows 2000, see
.
■
For Windows Me, see
■
For Windows 98SE, see