Air Comm Systems ACS 2010 - Manual (Page 5)

Air Comm Systems, Inc. Page 5
The ACS 2010 wiring harness should be constructed of Tefzel aircraft wire (M22759/16 grade). Power and
ground wires should be 18 or 20 AWG, and all other wires may be 22 AWG. Shielded wires should be used
where noted. Adequate protection against wear and chafing should be taken by using a braided cable sleeving
or jacket. Before completing installation, verify that all cable connector pins are seated properly and that the
connector is securely mounted to the unit mating connector.
Pre-fabricated cable harnesses are available from Air Comm to expedite installation — consult our sales
department for details.
POWER GROUND c
b
a
Z
Y
X
W
V
U
T
S
R
P
N
M
L
K
J
H
G
F
E
D
C
B
A
LIGHT DIM
ICS BUSS
PA KEY/MXD AUDIO
PA MIC HI
INPUT 5 AUDIO
INPUT 5 KEY
INPUT 5 MIC HI
INPUT 4 AUDIO
INPUT 4 KEY
INPUT 4 MIC HI
INPUT 3 AUDIO
INPUT 3 KEY
INPUT 3 MIC HI
INPUT 2 AUDIO
INPUT 2 KEY
INPUT 2 MIC HI
INPUT 1 AUDIO
INPUT 1 KEY
INPUT 1 MIC HI
SHIELD GROUND
HEADPHONE AUDIO
ICS KEY
TRANSMIT KEY
MICROPHONE HI
14 OR 28VDC POWER IN
ACS 2010
AUDIO PANEL
n
Connector Pin-out
ACS 2010 Operations and Installation Manual
Interface Schematic