Troubleshooting for anynet – Samsung LN52A610A3RXZP User Manual
Page 57
English -
troubleshooting for anynet
+
Symptom
Solution
anynet+ does not work.
■ Check if the device is an Anynet+ device. The Anynet+ system supports Anynet+
devices only.
■ Connect only one receiver (home theater).
■ Check if the Anynet+ device power cord is properly connected.
■ Check the Anynet+ device’s Video/Audio/HDMI1.3 cable connections.
■ Check whether Anynet+ (HDMI-CEC) is set to On in the Anynet+ setup menu.
■ Check whether the TV remote control is in TV mode.
■ Check whether it is Anynet+ exclusive remote control.
■ Anynet+ doesn’t work at a certain condition. (Searching channels, Operating
WISELINK, Plug & Play)
■ When connecting or removing the HDMI1.3 cable, please make sure to search
devices again or restart your TV.
■ Check if the Anynet+ Function of Anynet+ device is set on.
I want to start anynet+.
■ Check if the Anynet+ device is properly connected to the TV and check if the Anynet+
(HDMI-CEC) is set to On in the Anynet+ Setup menu.
■ Press the
tV button on the TV remote control to switch to TV. Then press the toolS
button to show the Anynet+ menu and select a menu you want.
I want to exit anynet+.
■ Select
View tV in Anynet+ menu.
■ Press the
SourCE button on the TV remote control and select a device other than
Anynet+ devices.
■ Press any of
Ch / and PrE-Ch to change the TV mode.
(Note that the channel button operates only when a tuner-embedded Anynet+ device
is not connected.)
the message Connecting to
anynet+ device... appears on the
screen.
■ You cannot use the remote control when you are configuring Anynet+ or switching to a
view mode.
■ Use the remote control when the Anynet+ setting or switching to view mode is
complete.
the anynet+ device does not play. You cannot use the play function when Plug & Play is in progress.
the connected device is not
displayed.
■ Check whether or not the device supports Anynet+ functions.
■ Check whether or not the HDMI1.3 cable is properly connected.
■ Check whether Anynet+ (HDMI-CEC) is set to On in the Anynet+ setup menu.
■ Search Anynet+ devices again.
■ You can connect an Anynet+ device using the HDMI1.3 cable only. Some HDMI
cables may not support Anynet+ functions.
■ If it is terminated by an abnormal situation such as disconnecting the HDMI1.3 cable
or power cord or a power failure, please repeat the device scan.
the tV program cannot be
recorded.
Check whether the antenna jack on the recording device is properly connected.
BN68-01429F-00Eng-0416.indd 55
2008-04-16 ¿ААь 10:17:58