beautypg.com

Installing your washer – Samsung WA45H7000AW-A2 User Manual

Page 16

background image

English - 16

sTep 4

Powering your washer

Plug the power cord into a 3-prong, well grounded 120 volt 60

Hz approved electrical outlet protected by a 15-amp fuse or

comparable circuit breaker.
Your washer is grounded through the third prong of the power

cord when plugged into a three-prong grounded electrical

outlet.

test run
Make sure that you install your washing machine correctly by running the rinse+spin cycle

after the installation is complete.

sTep 5

Running a test cycle

Run a test cycle as follows to check if your washer is properly installed.
1. Load about 6 pounds of laundry into the tub.
2. Press the power button to turn on your washer.
3. Select the Rinse+Spin cycle by turning the cycle selector.
4. Press the start/pause button to start the test cycle.
5. The washer should not rock or vibrate excessively when water is supplied or when washing

or spinning, and should drain well during the spin cycle.

If water leaks while water is being supplied or drained, check the water connections. Refer

to the “Connecting the water and the drain” section on pages 14

~15 for instructions.

If the washer rocks and vibrates excessively, level your washer again. Refer to the “Leveling

your washer” section on page 15 for instructions.

sTep 6

Calibration mode

Your Samsung washing machine detects the laundry weight automatically.

For more accurate weight detection, please run Calibration Mode after the installation.

To run Calibration Mode, follow these steps:
1. Remove laundry or any contents in the machine.
2. Press the Temp. and Delay End buttons simultaneously, and then press the Power button.

The machine turns on.
3. Press the start/pause button to activate “Calibration Mode”.
4. The pulsator rotates clockwise and counterclockwise for approximately 1 minute.
5. When “Calibration Mode” is finished, “End” (WA48H7400A*, WA45H7200A*) / “0”

(WA45H7000A*)

appears on the display, and the machine automatically turns off. The washing machine is now

ready for use.

installing your washer

WA7000HA WASH_WA48H_USER MANUAL_DC68-03133P-03_EN.indd 16

2014/3/25 10:45:27

This manual is related to the following products: