Samsung DV456ETHDSU-AA - Manual (Page 24)

24_ operating instructions, tips
operating instructions, tips
digital Graphic
display
The display window shows the estimated time remaining in the cycle after
you have pressed the Start/Pause button. The estimated time remaining may
fluctuates as the cycle progresses.
The Drying light will illuminate and remain lit until the cycle is complete.
When your dryer is in the cool-down phase, the Cooling light will illuminate. When
your dryer is in the wrinkle prevent phase, the Wrinkle Prevent light will illuminate.
When the cycle is complete, “End” will appear in the display panel until you push
the Start/Pause button or the Power button. If your dryer is paused during a
cycle, the indicator lights will blink until you press the Start/Pause button.
dry level
selection button
To select the dry level in the Normal, Heavy Duty, or other Sensor Dry cycles,
press the Dry Level button. An indicator light will illuminate next to the dryness
level you selected.
Press the button repeatedly to scroll through the settings. Larger or bulkier
loads may require the Very Dry or More Dry setting for complete dryness.
Damp Dry is designed to partially dry items. Use for items that lay flat or hang
to dry.
Temp selection
button
To select the temperature for the load, press the Temp button. An indicator
light will illuminate next to the temperature you selected. Press the button
repeatedly to scroll through the settings.
High – For sturdy cottons or those labeled Tumble Dry.
medium – For permanent press, synthetics, lightweight cottons, or items
labeled Tumble Dry Medium.
Low – For heat sensitive items labeled Tumble Dry Low or Tumble Dry Warm.
Extra Low – Provides the lowest heated drying temperature possible.
Time selection
button
When using Manual Dry cycles, you can adjust the drying time by pressing the
time selection button.
During the Sensory Dry cycle, the time light indicator is off because exact
drying times are determined by fluctuating humidity levels.
Therefore, the actual drying time may differ from the displayed time.
select Cycle
Option
Adjust Time – You can add or subtract time from the automatically set times
in the Wrinkle Away cycle and the Manual Dry cycles (Time Dry, Quick Dry, or
refresh cycles.)
To add or subtract time from the cycle, press the Adjust Time arrow pad up or
down until the desired time is displayed.
Wrinkle prevent - Wrinkle Prevent provides approximately 180 minutes
of intermittent tumbling in unheated air at the end of the cycle to reduce
wrinkling. Press the Wrinkle Prevent button to activate this feature.
The indicator light above the pad will illuminate when you select Wrinkle Prevent.
The load is dry and you can remove it at any time during the Wrinkle Prevent cycle.
mixed Load bell - The mixed load bell that notifi es you when the average
dry level in a load is damp dry (80 % dried). This lets you take garments that
you don’t want fully dried or that dry quickly out of the dryer early while letting
others continue to dry. You can select this function in all Sensor Dry cycles
except Sanitize. The dry level selections are limited to Normal Dry, More Dry,
and Very Dry.
Smart Care - Use this function to check if the Dryer is out of order using your
smart phone when the Dryer malfunctions. This function is set if you press and
hold the Mixed Load Bell key for 3 seconds.
start/pause
selection button
Press to pause and restart programs. 7
6
4
5
3
2
HUDSON STEAM DRYER_IB_DV456E(G)THDSU_DC68-03170C-03_EN.indd 24 2013-12-16 16:44:32