Samsung WA484DSHASU-A1 - Manual (Page 18)

18_ installing your washer
installing your washer
STEP 3
Leveling your washer
See if the washer is level by checking the position of the tub:
1. Slide the washer into position.
2. Open the lid of the washer, and pour the water into the tub to just
below the pulsator level.
3. If the washer is level, the pulsator is positioned at the center of the
water as shown in the fi gure. If not, level your washer by turning the
front leveling feet in or out as necessary.
Turn the front leveling feet clockwise to raise the height, and
counter clockwise to lower the washer.
STEP 4
Powering your washer
Plug the power cord into a 3-prong, well grounded 120 volt
60 Hz approved electrical outlet protected by a 15-amp fuse or
comparable circuit breaker.
Your washer is grounded through the third prong of the power cord
when plugged into a three-prong grounded electrical outlet.
Test run
Make sure that you install your washing machine correctly by running the Rinse+Spin cycle
after the installation is complete.
STEP 5
Running a test cycle
Run a test cycle as follows to check if your washer is properly installed.
1. Load your laundry (6 pounds) into the tub.
2. Press the Power button to turn on your washer.
3. Select the Rinse+Spin cycle by turning the Cycle Selector.
4. Press the Start/Pause button to start the test cycle.
5. Check if the washer does not rock or vibrate excessively while water is supplied, and that it
drains well during the spin cycle.
If there are any malfunctions such as a water leakage while water is supplied or drained, check
the water connection, referring to the “Connecting the water and the drain” section on page
16~17.
If the washer rocks and vibrates excessively, level your washer again, referring to the “Leveling
your washer” section on page 18.
Loosen Lock
Pulsator
Adjustable legs
WA484DSHA-03050D-01_EN.indd Sec3:18 WA484DSHA-03050D-01_EN.indd Sec3:18 2012-11-13 5:58:09 2012-11-13 5:58:09