Samsung TXS3064WRX-XAC - Manual (Page 16)

English-16
Storing Channels in Memory (Automatic Method)
1. Press the MENU button to display the menu .
Press the … … or † † button to select “Channel”, then press the ENTER button.
2. Press the … … or † † button to select “Auto Program”, then press the ENTER
button.
3. Press the ENTER button to start the auto program.
The TV begins memorizing all available channels.
Press the ENTER button at any time to interrupt the memorization process.
Press the EXIT button to exit.
Memorizing the Channels
Your TV can memorize and store all of the available channels for both “off-air” (antenna) and cable channels.
After the available channels are memorized, use the CH
or CH button to scan through the channels.
This eliminates the need to change channels by entering the channel digits. There are three steps for memorizing channels:
selecting a broadcast source, memorizing the channels (automatic) and adding and deleting channels (manual).
Selecting the Video Signal-source
Before your television can begin memorizing the available channels, you must specify the type of signal source that is connected to the
TV (i.e. an antenna or a cable system).
1. Press the MENU button to display the menu.
Press the … … or † † button to select “Channel”, then press the ENTER button.
2. Press the ENTER button to select “Air/Cable”.
Press the … … or † † button to select “Air”, “STD”, “HRC”, or “IRC”, then press
the ENTER button.
Press the EXIT button to exit.
Move Enter Return
TV Channel
Air/Cable : Air √ √
Auto Program √ √
Add/Delete √ √
Name √ √
Fine Tune √ √
Move Enter Return
TV Channel
Air/Cable : Air √ √
Auto Program √ √
Add/Delete √ √
Name √ √
Fine Tune √ √
Move Enter Return
TV Channel
Air/Cable :
Auto Program
Add/Delete
Name
Fine Tune
Air
STD
HRC
IRC
Search
Enter Return
Air 31
Stop
You can also press the AUTO PROG. button on the remote control to bring up the
Auto Program menu.
AA68-03871A-00Eng 7/18/06 6:07 PM Page 16