Samsung KN55S9CAFXZA User Manual
Quick start guide, Welcome to your new smart tv
BN68-05357A-03
QUICK START
GUIDE
Welcome to your new Smart TV!
The following instructions cover assembling, connecting, and setting up your new TV. Make
sure you have the accessories listed below.
Included in this box
Remote Control
One connect and Cables
Smart Touch Control
Power cord
IR extender
Batteries (AAA x 4)
RCA adapter x 2
Component adapter
One connect
Remote Control
One connect cable
Also included: User manual, 3D active glasses
Step
1
Attach the TV to
the Stand
Step
2
Connect video
devices
Step
3
Using the Smart
Touch Control
Step
4
Power on and
start the initial
setup
Warning: Screens can be damaged
from direct pressure when handled
incorrectly. We recommend lifting the
TV by the edges, as shown.
S9C
Step 1
Attach the TV to the Stand
1A
Open the package, and remove the cushioning.
Stand cover
Screws
Stand
M4 x L20 4 pieces
M4 x L10 2 pieces
x 4
x 2
1B
Pull the stand out of the top Styrofoam
cushioning, and make the stand face your body,
as shown in the illustration. Insert a finger
into the groove in the middle and pull it up to
separate the cover from the stand.
REQUIRED TOOLS: a Phillips head screwdriver and a soft, flat surface larger than the TV
(such as the box).
1C
Remove the TV from the box. Then, remove
the top and bottom pieces of Styrofoam from
the TV, but keep the screen-protection piece
on. Place the TV down on the the box with the
screen facing down.
1D
Hook
Tilt the stand to put its hook into the groove on
the back of the TV, and push it, giving it a slight
turn until it is firmly in place.
1E
M4 x L10
Secure the bottom of the stand to the TV using
two screws.
1F
M4 x L20
Secure the stand to the TV using four screws as
shown in the diagram.
1G
To replace the stand cover, fix its exterior and
then the interior into the stand. Press both
sides firmly to make sure that it is completely
assembled.
1H
Remove the port cover, and connect the power
cord to the One Connect.
1I
Replace the port cover.
1J
Stand the TV up, and remove the Styrofoam
bumper and the 4 protective pads from the
screen.
[S9C-QSG]BN68-05357A-03ENG.indb 2
2013-10-30 �� 5:19:12