Samsung HPS4253X-XAC - Manual (Page 15)

15
3 Tighten the screws of the plastic hanger
(shown in picture 2) to the back side of
the PDP. 4 Remove the Safety Pins. Fasten the 4
plastic latches assembled at step (#) on
the back side of the PDP using the guide
holes of the wall mount, push (!) and
hook (@) down to secure the PDP on
the wall mount as illustrated. Secure the
PDP by inserting the Safety Pins, not to
fall from the wall mount.
PDP
Wall Bracket Wall
How to Adjust Mounting Angle
Note Note : Please secure the mounting bracket on the wall surface after setting its angle at 0°
Hold onto the middle of the PDP
to adjust the angle (not the sides
of the PDP). 1. Secure the SET to the wall mount bracket.
(Please refer to the following instructions.)
2. Set the angle by pulling the upper end of the SET
attached to bracket in the direction of the arrow.
(Refer to the illustration on the right.)
3. The angle can be adjusted from 0° to 15° by ±2°.
BN68-00991B-01Eng(002~031) 2/17/06 1:56 PM Page 15