Samsung WF42H5600AW-A2 - Manual (Page 21)

English _21
select cycle
option
Press these buttons to select different cycle options.
pre Wash - To use this feature, add detergent to the pre wash section of the
detergent compartment. When turned on, the washer fills with cold water and
detergent, tumbles, then drains and advances to the selected wash cycle.
Some cycles cannot be selected with this option (See page 27~28).
extra rinse - Add an additional rinse at the end of the cycle to remove
laundry additives and perfumes more thoroughly.
extra spin - Add additional time to remove more water from loads.
steam - Press this button to use the Steam Wash function. Steam Wash is
available with the Normal, Heavy Duty, Bedding, Sanitize, Deep Steam and
Allergen cycles. For heavily soiled, colorfast garments, Steam Wash improves
stain treatment and uses less water (See page 25).
sound - When you activate the Sound off function, the “
” lamp illuminates.
my cycle - Choose your favorite cycle including temperature, spin, soil level,
options, etc. (see page 23)
delay end - Any cycle can be delayed for up to 24 hours in one-hour
increments. Displayed hour indicates the time at which the wash will be
started. (See page 22).
self clean+ - Use to clean dirt and possible mold from the drum. Regular
use (after every 40 washes) is recommended. No detergent or bleach is
needed (see page 31).
super speed - Press this button if you need to shorten the washing time,
applicable for Normal, Deep steam, Heavy Duty, Bedding or Allergen course.
The shortened time may differ depending on the Cycles/Load/Option.
start/pause
selection button
Press to pause and restart programs.
power button
Press once to turn your washer on, press again to turn your washer off. If
the washer is left on for more than 10 minutes without any buttons being
touched, the power automatically turns off.
Child Lock
Child Lock prevents children from playing with your washer.
Once you have activated the Child Lock function, the control panel cannot be activated,
preventing children from playing with the washer.
Activating the Child Lock function
Press and hold both the soil level and spin buttons simultaneously for 3 seconds.
• When you activate the Child Lock function, the door locks and the “Child Lock ” lamp
illuminates.
• If you press the sTarT/pausE button after you have activated the Child Lock function , none of
the buttons will work except for the powEr button.
• If you press a button when the buttons are locked, the “Child Lock ” lamp blinks.
Pausing the Child Lock function
When the door is locked or the buttons are locked by the Child Lock function, you can pause the
Child Lock operation for 1 minute by pressing and holding both the soil level and spin buttons
simultaneously for 3 seconds.
• If you pause the Child Lock mode temporarily, the door lock is released for 1 minute for user
convenience. During this period, the “Child Lock ” lamp blinks.
• If you open the door after the minute is over, an alarm sounds for up to 2 minutes.
• If you close the door within the 2 minutes, the door is locked and the Child Lock function is
reactivated. If you close the door after the 2 minutes, the door is not locked automatically and
no alarm sounds.
03 washing a load of laundr
y
6
7
8
Premium-WF42H5700-03386A-02_EN.indd 21 2014/5/4 16:40:33