Samsung WA456DRHDSU-AA - Manual (Page 14)

14_ installing your washer
Required dimensions for Installation
IMPoRTAnT noTE To InSTALLER
Please read the following instructions carefully before installing your washer.
These instructions should be retained for future reference.
We recommend you hire a professional to install this washer.
Installation Flow chart
STEP 1 Selecting a Location
Before you install the washer, make sure the location:
• Has a hard, level surface without carpeting or flooring that may obstruct ventilation.
• Is away from direct sunlight.
• Has adequate ventilation.
• Is not exposed to freezing temperatures (temperatures under 32 °F or 0 °C).
• Is away from heat sources such as oil or gas.
• Has enough space so that the washer doesn’t rest on its power cord.
installing your washer
27.0 in.
(68.6 cm)
43.9 in
(111.5 cm)
39.3in
(99.8 cm)
29.3 in
(74.4 cm)
29.3 in
(74.4 cm)
43.9 in
(111.5 cm)
58.1 in
(147.6 cm)
Closet or Door
48 in.² *
(310 cm²)
24 in.² *
(155 cm²)
3 in.
(7.6 cm)
3 in.
(7.6 cm)
*Required spacing
Selecting
a location
Removing the
shipping bolts
(*Drum only)
Adjusting the
levelling feet
Connecting the water
and the drain
[Running a test cycle]
Run a test cycle(Rinse+Spin)
with small amount of laundary
(about 4~5 Towels)
Running
a Calibration
mode
Powering your
washing machine
Finish the
installation
Does a
Laundary machine
Vibrate?
No
Yes
Please check again before steps.
HUDSON WASH_WA456_USER MANUAL_DC68-03133A-08_EN.indd 14 2014-3-1 14:10:15