Samsung DMT400RHS-XAA - Manual (Page 26)

26_ troubleshooting
INFORMATION CODES
The Control Panel displays information codes to help you understand what is occurring with your
dishwasher. If you see any of the codes listed below, you should select the Cancel and Drain option, and
then follow the instructions in the Solution column.
If your dishwasher have any problem, below CODE SYMBOL light(s) is(are) blinked.
CODE SYMBOL MEANING SOLUTION
Temperature Sensor error
Functional error. With the dishwasher empty, add
detergent, and then run a cycle.
If the problem continues, go to your house circuit breaker
panel, set the dishwasher’s circuit breaker switch to off,
and then contact an authorized Samsung service center. Heater error
High temperature
Heating error
Low-level water error
Water supply error
Check whether the water supply valve is closed, the water
supply is suspended or the water inlet valve or line is
frozen or clogged by foreign particles.
If the problem continues, close the water supply valve, and
then contact an authorized Samsung service center.
High temperature Water
supply error
Check the temperature of the supplied water. If it is higher
than 176 ˚F (80 ˚C), a functional error may occur with the
dishwasher.
Drain error
Check whether the drain hose is clogged or folded. If the
problem continues, close the water supply valve, and then
contact an authorized Samsung service center.
Over-level water error
Functional error. Close the water supply valve and go to
your house circuit breaker panel, set the dishwasher’s
circuit breaker switch to off, and then contact an
authorized Samsung service center.
Leakage error
Button error
Functional error. Turn off the dishwasher and try to start it
again.
If the problem continues, contact an authorized Samsung
service center.
Communication Error
For any codes not listed above, call 1-800-SAMSUNG (726-7864)
troubleshooting
DMT400_DD68-00074A-04_EN_20120913.indd Sec7:26 DMT400_DD68-00074A-04_EN_20120913.indd Sec7:26 2012-09-13 3:55:57 2012-09-13 3:55:57