beautypg.com

Alloy Computer Products POE100 Series User Manual

Page 9

background image

Note:

1. S1-2 and S1-3 will take effect only when S1-1 is set to TP-Force
2. S1-5 must be set to 100FDX for Single Fibre Model
3. S1-6 must be set to POE when you need to supply power to a PD.


Warning:

- When the copper port is set to AUTO and is connected to a device that

is forced to 100Mbps FDX, an unknown state may result.

- Please ensure that all network nodes that this device connects to are

set to the same mode at each end of the link.
e.g., Both ends are set to Auto-Negotiation mode (AUTO)

9. Cable Distances and Limitations

- TP Cable Limitations: Cat 5 up to 100m
- Fibre Cable Limitations:

SC/ST Converter Models

Multi Mode Half Duplex

412m

Multi Mode Full Duplex

2Km

Single Mode Half Duplex

412m

Single Mode Half Duplex 5/20/40/60/80/100Km




10. Technical Specifications


Standards:

IEEE 802.3u 10/100Base-TX, 100Base-FX
IEEE 802.3af Power Over Ethernet

UTP Cable:

Cat. 5 cable up to 100m

Fibre Cable:

50/125, 62.5/125 or 100/140 µm multi mode
8.3/125, 8.7/125, 9/125 or 10/125 µm single mode

Power Feeding
Support:

Via TP Pins 1, 2, 3 and 6

LED Indicators:

Power, POE, TP LNK/ACT, 100, FX LNK/ACT,
FDX/COL, 4W, 7W, 15.4W

Data Transfer Rate:

100Mbbps – 148,800pps
10Mbps – 14,880pps

Flow Control:

IEEE 802.3x compliant for Full Duplex
Backpressure flow control for Half Duplex

Power Requirements:

AC 100 ~ 240V 50 ~ 60Hz

Power Consumption:

24W

Ambient Temperature: 0º to 50º C
Humidity:

5% to 90%

Dimensions:

40(H) x 158(W) x 133(D) mm

Complies with C-Tick, FCC Part 15 Class A and CE Mark