Avanti PAC12000 - Manual (Page 11)

11
REMOTE CONTROL STRUCTURE AND OPERATION
The remote control uses 2 alkaline dry batteries (AAA 1.5V).
To install the batteries, slide back the cover and mount them according to the signs (+ and -) shown
on the rear compartment.
NOTE:
If you plan not to use the control for several weeks, remove the batteries. When replacing the
batteries, do not mix old and new.
Replace the batteries when the transmission indicator light fails to appear.
O N/ O FF
S w ing B utton:
Ipress sw ing button to
auto adjust a right and left
direction of w ind
Fan speed B utton:
P ress once can
change fanspeed at
sequence of Low ,M id
and H igh speed.
O N /O FF B utton:
P ress once to
start,and press
again to stop.
M ode B utton:
P ress once w ill
change the unit run
m ode.
T im er B utton:
U nit can be auto O FF if the
unit is under running and
the unit is ready.
Tem p B utton:
P ress this button "+" once
setting room tem perature
w ill increase 1
℃.
P ress this button "-" once
setting room tem perature
w ill decrease 1
℃.
TIM E R
_
S P E E D
+
S W IN G
M O D E
℃/ ° F
℃/ °
F B utton
E very tim e press this
botton, the m achine
control panel show s the
tem perature in
°
C or F
on the conversi
Remote control (Auto mode)
The compressor and fan motor will cycle on or off according to the room temperature
to keep the room comfortable.
Remote control (cooling mode)
Setting temperature range 15-31ºC
（59-88°F）.
When the room temperature sensor’s temperature is higher than the set
temperature, the compressor starts to run.
When the room temperature sensor’s temperature is lower than the set
temperature, the compressor stops and fan operates at original speed.
Remote control (Fan mode)
Fan mode: the compressor and lower fan motor stop, upper fan run at set
speed, in this case, temperature setting becomes invalid.
Remote control (Dehumidifying mode)
Dehumidifying mode: the compressor and lower fan are running and the upper fan is
running at low speed.