Audiovox LCMR6CT - Manual (Page 6)

(4)
Installing the Temperature Sensor.
a) Select a suitable location for the Temperature sensor outside of the vehicle. The
location should be in the nose area of the vehicle, between the front of the radiator
and front bumper where there will be airflow. Keep the sensor as low as possible,
and as far away from the radiator as possible.
b) Use the supplied screw to secure the temperature sensor to the selected location.
c) Route the temperature sensor cable towards the firewall, securing the cable
where it doesn't interfere with moving parts.
d) Pass the terminals thought a grommet into the passenger compartment,
e) Route the wires up to and behind the A pillar, then under the headliner towards
the Rearview mirror.
Figure 2
f) Insert the terminals into the two-pin connector until a snap is heard.
g) Connect the 6-pin Temperature/Compass Y cable to the rearview
mirror/monitor cable.
h) Connect the 2-pin connector from the sensor to the mating end of the
Temperature/ Compass Y cable.
(5) Installing the Compass sensor:
a ). Select a suitable mounting location for the compass sensor. The sensor must
be mounted horizontally and with the Arrow pointing towards the front of the
vehicle. Do not mount near a speaker or magnetic source. Under the dash top
panel is a recommended location.
5