Resetting to the factory default settings – Axis Communications 210 User Manual
Page 47

47
AXIS 210/210A/211/211A - System Options
Resetting to the Factory Default Settings
To reset the cameras to the original factory default settings, go to the System Options >
Maintenance web page (as described in Maintenance, on page 44) or use the Control
button on the underside of the camera (see page 7) as described below:
Using the Control Button
To reset the cameras to the factory default settings using the Control Button:
1. Disconnect the power adapter, or the network cable if using PoE
(AXIS 210A/AXIS 211/211A only).
2. Press and hold the Control button while reconnecting the power.
3. Keep the Control button pressed until the Status Indicator color changes to amber
(this may take up to 15 seconds).
4. Release the Control button.
5. When the Status Indicator changes to Green (which may take up to 1 minute), the
process is complete and the cameras has been reset. The unit will now have the
default IP address 192.168.0.90