Acura 2009 RDX - Manual (Page 177)

CONTINUED
You can use any of five methods to
find radio stations on the selected
band: tune, seek, scan, the preset
bars, and auto select.
Use the TUNE/FOLDER
bar to tune the radio to a desired
frequency. Press the
side of the
bar to tune to a higher frequency,
and the
side of the bar to tune
to a lower frequency.
The SEEK function
searches up and down from the
current frequency to find a station
with a strong signal. To activate it,
press the
or side of the
SEEK/SKIP bar, then release it.
If you press and hold the or
side of the bar, the frequency
will begin to change rapidly. It will
stop when you release it.
The SCAN function
samples all stations with strong
signals on the selected band. To
activate it, press the SCAN button,
then release it. You will see ‘‘SCAN’’
on the center display. The system
will scan for a station with a strong
signal. When it finds one, it will stop
and play that station for about 10
seconds.
If you do nothing, the system will
then scan for the next strong station
and play it for 10 seconds. When it
plays a station you want to listen to,
press the SCAN button again.
Each side of the bars (1
6) can store one frequency on AM
and two frequencies on FM.
Select the desired band, AM or
FM. FM1 and FM2 let you store
two frequencies with each side of
the preset bar.
Use the TUNE, SEEK, or SCAN
function to tune the radio to a
desired station.
Pick the preset number (1 6), for
the station you want to store.
Press the left or right side of the
bar, and hold it until you hear a
beep.
Repeat steps 1 through 3 to store a
total of six stations on AM and
twelve stations on FM.
1.
2.
3.
4.
To Select a Station
TUNE
SEEK
SCAN Preset
Audio System
Fe
a
tu
re
s
171