AEG KO_FAVORIT 80800 - Manual (Page 12)

Operating Instructions
12
0 1. The dishwasher must be switched off.
2. Press the signal tone and water softener buttons simultaneously and
keep them pressed
3. Press the ON/OFF switch. The LED indicators for the signal tone and
water softener buttons flash.
4. Press the softener button again.
The multi-display indicates the hardness setting.
5. Pressing the hardness button increases the hardness setting by 1.
(Exception: Hardness setting 0 follows hardness setting 9).
6. Once the hardness setting is correctly adjusted, press the ON/OFF
switch.
The hardness setting is then saved.
Filling with Special Salt for the Water Softener
1 Use only special salt intended for dishwashers. Never fill the salt con-
tainer with different types of salt (e.g. cooking salt) or detergent. This
would destroy the water softener.
Prior to filling with salt, please check each time that you really do have
a packet of special salt in your hand.
Fill with special salt:
– Before putting the dishwasher into operation for the first time.
– When the indicator lamp for special salt (ZOUT; SEL) lights up on the
control panel.
3 If the water hardness in your area is less than 4 °d, you do not need to
use special salt.
0 1. Open the door, remove the lower
rack.
2. Undo the lid on the salt container by
turning it anticlockwise.
3. Only when using for the first time:
fill the salt container with water.
4. Place the funnel supplied on the
container opening.
Fill the container with special salt
through the funnel; the capacity of
the container is approx. 1.0-1.5 kg
depending on the grain size. Do not
overfill the salt container with special salt.
SALE
SAL
T
SALZ
SEL