Tamerica Products TCC-1200 - Manual (Page 7)

LAMINATING PROCEDURES
1. Make sure the print is aligned and set properly onto the mounting board.
2. Release the handle from the locked position and insert the handle pin into the “MIN” notch to
engage the rollers. The user can now start as the machine starts feeding in film.
3. Step on the foot pedal to feed the film in. Keep feeding film until wrinkles are evened out before
feeding the print and board. For more information on how to optimize the use of the foot pedal, please
see B. FOOT PEDAL OPERATION.
4. To put the lamination temporarily on hold without turning off the machine, release the locked handle
and push it back to the 3/16” notch to disengage the rollers. This will separate the rollers and stop
the motor from feeding more film.
5. Pull the handle back to the “MIN” setting to reengage the rollers and resume the lamination job.
B. FOOT PEDAL OPERATION
This machine is equipped with a foot pedal for easier threading and overall operation.
Note:
1. Press and hold motor speed arrow down button until the display shows 0. In this setting, the motor
will not run and rollers will not feed in the film. Stepping on the foot pedal in this instance will
activate the motor and start feeding the film. The motor will stop as soon as pressure is released
from the foot pedal.
2. If the speed is on “1” or higher, stepping on the foot pedal will automatically make the motor go to
speed “9” and the rollers will start feeding film faster. Releasing the foot pedal in this instance will
cause the speed to go down to the machine’s current speed setting.