Tamerica Products TCC-1200 - Manual (Page 10)

H. AUTO SHUT-OFF FUNCTION
This machine is equipped with an auto shutoff feature. The following is a step by step diagram of its
operation:
CONTROL PROCESS FOR AUTO SHUT OFF
USER SETS MOTOR SPEED TO 0
STAGE 1 BY PRESSING AND HOLDING
ARROW DOWN MOTOR BUTTON
WHEN LEAVING THE MACHINE
UNATTENDED
↓
MOTOR STOPS RUNNING
STAGE 2 IMMEDIATELY (AVOIDS FILM
FEEDING) AND PCB
STARTS COUNTING TIME
END USER RETURNS AND RESETS MOTOR
SPEED OR STEPS ON FOOT PEDAL WITHIN USER CAN START
→ 60 MINUTE PERIOD, PCB STOPS COUNTING → LAMINATING AGAIN
TIME
↓
TEMPERATURE STARTS
COOLING DOWN TO 100°C (212°F)
AFTER 60 MINUTE PERIOD
STAGE 3
END USER RETURNS AFTER 60 MINUTE
PERIOD, RESETS MOTOR SPEED OR STEPS USER CAN START
→ ON FOOT PEDAL, PCB STOPS COUNTING, → LAMINATING AGAIN
TEMP.ERATURE GOES TO PREVIOUS
SETTING
↓
THE TEMPERATURE GOES DOWN
STAGE 4 TO 100°C (212°F) AND TURNS OFF
THE POWER AFTER ANOTHER 30
MINUTES
REMARK: AT STAGE #4, THE MACHINE IS OFF BUT THE POWERSWITCH IS AT THE "ON" POSITION.
THE END USER NEEDS TO TURN THE POWER SWITCH OFF AND THEN ON AGAIN TO
RESTART THE MACHINE. PRESS THE HOT BUTTON TO RETURN TO PREVIOUS TEMPERATURE.
CONTINUE THE LAMINATION JOB AS SOON AS PREVIOUS TEMPERATURE IS REACHED. TO
DISENGAGE AUTO SHUTOFF FEATURE, TURN “AUTO SHUTOFF” SWITCH OFF.