beautypg.com

Safety information, Training, Operator qualifications – Wesley SCT-7750-8AC User Manual

Page 6: Safety guidelines

background image

Owner’s Manual and Service Guide – SC & SCT Series

6

SAFETY INFORMATION


The responsibility of safety lies with four main groups: manufacturers, owners/lessees, operators and maintenance personnel.
This manual has been designed to assist the owner-operator in operating and maintaining the vehicle in a safe manner, in
accordance with the procedures and standards to which the vehicle was designed and intended for use.

T

RAINING

Vehicle owners/lessees a

re responsible for instructing their personnel in its safe operation. Owners must explain the vehicle’s

characteristics, features, operation of its controls, and safe driving practices. We strongly recommend that owners first be come
familiar with the conditions of the place where the vehicle will be operated in order to assess its effect on safe operation. Training
should occur under the conditions of the operating environment while adhering to the safety guidelines and include:

Safety guidelines

Operation of the vehicle under the conditions in which it will be operated

Operation of all controls

Safe driving practices

A driving and operating test

O

PERATOR

Q

UALIFICATIONS

Operators should be selected based on their ability to safely operate the vehicle, including vision, hearing, physical and mental
capabilities. Operators must:

Demonstrate a working knowledge of all controls

Understand all safety guidelines

Be able to properly drive and park the vehicle under the conditions in which the vehicle will be used

Know how to properly load and unload cargo and passengers

Recognize maintenance problems

S

AFETY

G

UIDELINES

All Pack Mule vehicles are designed for use on smooth surfaces in and around industrial plants, warehouses, nurseries and
greenhouses. While made of components that are unaffected by the rain, they are not intended for continuous outdoor use,
traversing up and down steep grades, or travelling on public roads/highways as the tires are not configured for these purposes.

Follow these guidelines to safely drive the vehicle:

Read, understand and observe all labels affixed to the vehicle

Do not start the vehicle without checking the brakes first

Do not mount or dismount the vehicle when the key is in the ON position

Do not drive the vehicle if the accelerator requires excessive pressure

Do not park or operate the vehicle near flammable objects or in a flammable or hazardous environment

Use only necessary power

Keep both hands on the steering wheel while operating the vehicle

Accelerate and decelerate slowly and in a controlled manner

Always reduce speed to compensate for poor terrain or conditions

Always maintain adequate distance between vehicles, people, and obstacles

Do not use the vehicle to push objects

Do not allow the tires to lose contact with the ground

Proceed around low overhangs with caution. Be sure there is enough clearance for the operator’s head and the highest
point of the vehicle or any attached accessories.

Never abruptly change direction

Always drive directly up an incline; never across

Never exceed the designated passenger, load or towing capacity

On grades, it is possible for vehicles to coast at greater than normal speeds encountered on a flat surface. To prevent loss of
vehicle control and possible serious injury, speeds should be limited to no more than maximum speed on level ground.

Good common sense and prudent driving practices do more to prevent accidents and injuries than all of the warnings and
instructions combined. Wesley International strongly suggests that the owner-operator read this entire manual paying particular
attention to the CAUTIONS and WARNINGS contained therein.