Campbell Scientific SP-LITE Solar Radiation Sensor User Manual
Page 10
SP-LITE Silicon Pyranometer
6
FIGURE 7. 025STAND and 019ALU Crossarm
Mount the sensor on the mounting arm at a height of at least 1.5 m above the
ground surface to minimize shading effects. PN 14282 mounting bracket has a
built-in bubble level that is used to mount the SP-LITE to the 025STAND or
015ARM. Mount and adjust the SP-LITE as follows:
1.
Attach the mounting arm to the tripod or tower at the required height.
2.
Loosely attach the 14282 Kipp & Zonen Base and Leveling fixture to the
mounting arm using the three mounting screws provided with the
mounting arm (025STAND or 015ARM).
3.
Level the 14282 by adjusting the three outside leveling screws as required
to center the bubble in the level. Tighten the three mounting screws.
4.
Attach the SP-LITE to the 14282 using the two screws provided.
SP-LITE
025STAND
019ALU Crossarm