Campbell Scientific PWC100 Present Weather Sensor Calibrator - Manual (Page 5)

PWC100 Table of Contents
PDF viewers: These page numbers refer to the printed version of this document. Use the
PDF reader bookmarks tab for links to specific sections.
1. Introduction..................................................................1
2. Operation and Use.......................................................1
2.1 Operating Guidelines................................................................................1
2.2 Initial Configuration of the PWS100 for use of the Calibrator.................2
3. PWS Calibration...........................................................2
3.1 Installing and Connecting up the Calibrator .............................................3
3.2 Starting the Tests ......................................................................................4
4. Cleaning Guide ..........................................................10
5. Calibrator Safety Guidelines.....................................10
6. Electrical Parameters ................................................11
6.1 PWC100 Voltages and Currents.............................................................11
6.2 Earth, 0 V and Transient Protection .......................................................11
Appendix
A. Assembly Guidelines.............................................. A-1
A.1 Assembly Guidelines .......................................................................... A-1
A.2 Connector Pin Outs............................................................................. A-2
Figures
2-1. PWS100 calibration disk constants .........................................................2
3-1. The PWS100 enclosure showing the LEMO connector used by the
calibrator ..............................................................................................3
A-1. Attaching the velocity disk................................................................ A-1
A-2. Attaching the visibility disk............................................................... A-1
A-3. Attachment of the velocity calibrator ................................................ A-2
i