Kinivo BTE40 Bluetooth Stereo Headphones EN - Manual (Page 9)

Kinivo BTE40 Stereo Bluetooth Earphones 9
Bluetooth pairing mode
While the earphones are powered on, press
and hold the Call button for two to three
seconds until the red and blue LED start
alternately blinking
Voice command / dialing
(Siri for supported
iPhones)
To use this feature your mobile device must
support the voice dialing/command function.
1. Press the call / multifunction button
once.
2. Give voice command.
Press the multifunction button again to
cancel voice command.
Answer call
End call
Press multifunction button once (Note -this
will end the current call and answer the new
call )
Redial last number
Press the call button twice (double click
quickly)
Refuse incoming call
Press and hold multifunction button for 2
seconds
Toggle microphone
mute (during a call)
Press VOL- and VOL+ at the same time and
release immediately
Switch audio between
phone and BTE40
While in a call, press and hold multifunction
button for 2 seconds