Asus Motherboard P5Q-VM - Manual (Page 83)

ASUS P5Q-VM 2-27
2.5.2 Chipset
The Chipset menu allows you to change the advanced chipset settings. Select an
item then press to display the sub-menu.
North Bridge Configuration
Memory Remap Feature [Enabled]
Allows you to enable or disable the remapping of the overlapped PCI memory
above the total physical memory. Enable this option only when you install
64-bit operating system. Configuration options: [Disabled] [Enabled]
Initiate Graphic Adapter [PEG/IGD]
Allows you to decide which graphics controller to use as the primary boot
device.
Configuration options: [IGD] [PCI/IGD] [PCI/PEG] [PEG/IGD] [PEG/PCI]
IGD Graphics Mode Select [Enabled, 32MB]
Allows you to select the amount of system memory used by the internal
graphics device.
Configuration options: [Enabled, 32MB] [Enabled, 64MB] [Enabled, 128MB]
GTT Graphics Memory Size [No VT mode, 2MB]
This item is not available.
PAVP Function [Disabled]
Allows you to set the GMCH Protected Audio Video Path (PAVP) BIOS
support. Configuration options: [Disabled] [Lite Mode] [Paranoid]
DVMT Memory [256MB]
Configuration options: [128MB] [256MB] [Maximum DVMT]
The [Maximum DVMT] option appears only when you install DIMM modules
more than 1 GB.
Advanced Chipset Settings
WARMING: Setting wrong values in below sections
may cause system to malfunction.
North Bridge Configuration
Configure North Bridge
features.
BIOS SETUP UTILITY
Advanced
North Bridge Chipset Configuration
Memory Remap Feature [Enabled]
Initiate Graphic Adapter [PEG/IGD]
IGD Graphics Mode Select [Enabled, 32MB]
GTT Graphics Memory Select [No VT mode, 2MB]
PAVP Function [Disabled]
DVMT Memory [256MB]
BIOS SETUP UTILITY
Advanced
ENABLE: Allow
remapping of
overlapped PCI memory
above the total
physical memory.
DISABLE: Do not allow
remapping of memory.