Weems and Plath Endurance 125 Clock - Manual (Page 3)

Installation Instructions
1. With the instrument face downward on a clean soft surface or lap,
and with the 12 o'clock position of the instrument towards you, push
the rear molded black mounting plate of the Weems Slide 'n Lock
mounting system in a sliding motion away from you. This may require
some force to overcome the locking dimples.
2. Select the center point where you want to mount the instrument's
mounting plate on the wall or bulkhead. It is important that the mounting
surface be flat for at least a diameter of 8".
3. Lightly draw 2 lines, one horizontal and one vertical through the center
point you have selected. Each line should be about 5" to 6" long,
centered on the center point of the mounting plate.
IMPORTANT: Please read Additional tips section below
before continuing.
4. Place the mounting plate firmly on the center point ensuring that the
Weems & Plath logo and part number are upright. Align the 4 existing
recessed lines on the front face of the mounting plate with the pencil
lines previously marked on the wall or bulkhead.
5. Using a pointed tool or pencil, mark through 4 holes to position the
mounting screws on the wall surface.