Apple Xserve (Single-Slot Riser Card Replacement) - Manual (Page 5)

Xserve Single-Slot Riser Card - 5
4. Disconnect the PCI or AGP card from the riser. (Figure 5)
Figure 5
Installing the Replacement Single-Slot Riser Card
1. Install the PCI or AGP card in the replacement riser card.
2. Reconnect the riser card to the logic board.
3. Tighten the thumbscrew that secures the PCI or AGP card fence to the back of the
server.
Closing the Server
1. Carefully slide the bottom housing back into the rack.
2. Tighten the front thumbscrews to secure it.
Warning: Never turn on the server unless all of its internal and external parts
are in place and it is closed. Operating the server when it is open or missing
parts can damage it or cause injury.