Audiovox AVD300 - Manual (Page 7)

6
F. Connections
Figure 3
1. Powering Your DVD Player ( Refer to Figure 3)
Connect the black wire (-) to the vehicle ground. Connect the red
wire (+) to a switched (Accessory) 12VDC source. Plug the other
end into the 12VDC input jack on the rear of the unit.
2. Remote IR Receiver ( Refer to Figure 3)
Plug the 1/8” jack on the remote IR cable into the IR IN jack on the
rear of the DVD player. Place the IR receiver anywhere in the
vehicle to allow remote control in any location.