Acer X233HZ - Manual (Page 19)

19
Installation
To install the monitor to your host system, please follow the steps as given below:
Steps 1.
1-1 Connect Video Cable
a. Make sure both the monitor and computer are powered-OFF.
b. Connect the VGA video cable to the computer.
1-2 Digital Cable (Only Dual-Input Model)
a. Make sure both the monitor and computer are powered-OFF.
b. Connect one end of the 24-pin DVI cable to the back of the monitor and connect the other end to the computer’s
port.
Steps 2. Connect power cord
Connect the power cord to the monitor, then to a properly grounded AC outlet.
Steps 3. Power-ON Monitor and Computer
Power-ON the monitor first, then power-ON the computer. This sequence is very important.
Steps 4. If the monitor still does not function properly, please refer to the troubleshooting section to diagnose the
problem.
http://www.wjel.net