Siemens TS22XTRM - Manual (Page 20)

20
SIEMENS
ENG
lISH
Trouble shooting
problem possible causes Solution
Pilot light (12*)
flashes
Boiler and filter must be rinsed. Rinse the filter and the boiler according
to the cleaning instructions in this
manual (see section E).
The steam generator
does not come on.
• There is a connection problem.
• The main power switch is not
switched on.
• Check the mains cable (6), the plug
and the socket.
• Set the main power switch (13) to the
“I” position.
The iron does not
heat up.
• The main power switch is not
switched on.
• The temperature is set to a low
position.
• Set the main power switch (13) to the
“I” position.
• Set the temperature to the desired
position.
The iron begins to
smoke when
switched on.
• During first use: certain
components on the appliance
have been lightly greased at the
factory and may produce a little
smoke when initially heated.
• During subsequent use: the
soleplate may be soiled.
• This is completely normal and will stop
after a short while.
• Clean the soleplate according to the
cleaning instructions in this manual.
Water flows through
the holes on the
soleplate.
• The steam function is being used
before it has reached the correct
temperature.
• The water is condensing inside
the pipes because steam is being
used for the first time or has not
been used for a long time.
• The steam generator contains too
much scale.
• Reduce the steam flow when ironing at
low temperatures.
• Point the iron away from the ironing
area and press the steam release
button until steam is produced.
• Clean the boiler as described in
section “Calc'n'Clean Advanced” (E).
Tips to help you
save energy
Steam production consumes the most energy. To
help minimise the energy used, follow the advice
below:
• Start by ironing the fabrics that require the
lowest ironing temperature.
Check the recommended ironing temperature
in the label on the garment.
• Regulate the steam according to the selected
ironing temperature, following the instructions
in this manual.
• Try to Iron the fabrics while they are still damp
and reduce the steam setting. Steam will be
generated from the fabrics rather than the iron.
If you tumble dry your fabrics before ironing
them, set the tumble drier on the ‘iron dry’
programme.
• If the fabrics are damp enough, turn off the
steam regulator completely.
advice on disposal
Our goods come in optimised packaging. This
basically consists in using non-contaminating
materials which should be handed over to the
local waste disposal service as secondary raw
materials. Your local town council can give you
information about how to dispose of obsolete
appliances.
This appliance is labelled in
accordance with European Directive
2012/19/EU concerning used
electrical and electronic appliances
(waste electrical and electronic
equipment - WEEE).
The guideline determines the
framework for the return and
recycling of used appliances as applicable
throughout the EU.