Siemens VS06G2424 - Manual (Page 42)

41
Changing the dust bag
Replacing the dust bag
Figure
a) If the dust bag change indicator is completely yellow
when the floor tool is lifted from the floor and the highest
suction power is selected, the dust bag must be
changed. In this case it is essential to change the dust
bag due to the type of material it contains.
The nozzle, suction pipe and flexible tube
must not be blocked, as this would also cause the dust
bag change indicator to be triggered.
b) The handle can easily be detached from the hose to
remove blockages.
Figure
Open the lid by moving the locking lever in the direction
of the arrow.
Figure
a) Seal the dust bag by pulling the sealing strip and then
remove it.
b) Slide the new dust bag into the holder to the stop.
! Caution: The lid only closes with a dust bag inserted.
Cleaning the motor protection filter
The motor protection filter should be cleaned regularly by
knocking out the dirt and rinsing.
Figure
Ⅲ Open the dust bag compartment lid (see Figure 19).
Ⅲ Pull out the motor protection filter in the direction of the
arrow.
Ⅲ Clean the motor protection filter by tapping it.
Ⅲ If it is very dirty, the motor protection filter should be
rinsed.
The filter must then be left to dry for at least 24 hours.
Ⅲ After cleaning, slide the motor protection filter into the
vacuum cleaner and close the dust bag compartment lid.
Replacing the micro-hygiene filter
The motor protection filter should be changed: when
starting a newpack of bags
Figure
Ⅲ Open the dust bag compartment lid (see Figure 19).
Ⅲ Release the filter holder by moving the locking lever in
the direction of the arrow.
Ⅲ Remove the micro-hygiene filter. Insert the new micro-
hygiene filter into the vacuum cleaner.
Ⅲ Reinsert the filter holder and clip into place.
22
21
20
19
18*
Replacing the micro active carbon filter
If your vacuum cleaner is equipped with a micro active
carbon filter, this should be replaced every six months.
Figure
Ⅲ Open the dust bag compartment lid (see Figure 19).
Ⅲ Release the filter holder by moving the locking lever in
the direction of the arrow.
Ⅲ Remove the micro active-carbon filter.
Ⅲ Insert the new micro-active carbon filter.
Ⅲ Reinsert the filter holder and clip into place.
Replacing the Hepa filter
If your vacuum cleaner is equipped with a Hepa filter, this
should be replaced once a year.
Figure
Ⅲ Open the dust bag compartment lid (see Figure 19).
Ⅲ Release the Hepa filter by moving the locking lever in the
direction of the arrow and remove it from the vacuum
cleaner.
Ⅲ Insert the new Hepa filter and clip into place.
If you have used the vacuum cleaner for fine dust particles,
clean the motor protection filter and, if necessary, replace
the micro active carbon filter or Hepa filter.
Care
Always switch off the vacuum cleaner and disconnect the
power cord from the mains before cleaning the appliance.
The vacuum cleaner and plastic accessories can be
cleaned with a commercial plastic cleaner.
! Do not use a scourer, glass-cleaning agent or all-
purpose cleaning product. Never immerse the
vacuum cleaner in water.
The dust compartment can, if necessary, be cleaned with a
second vacuum cleaner or simply wiped with a a dry cloth
or dusting brush.
Subject to technical modifications.
24
23
*Depending on equipment