Siemens TN20350 - Manual (Page 13)

13
S I E M E N S
EN
G
lI
SH
hot so that it passes through the cover and board
to be expelled without condensing.
recommendation:
• Through the suction function, light fabrics (silk
etc.) can be held in place on the ironing board,
preventing them from slipping.
• The suction function cools the fabric and ixes the
results of the ironing, guaranteeing. perfect folds
BlOWING FUNCTION
The blowing allows you to iron without downward
pressure on a cushion of air. This makes ironing
of delicate items, or dificult areas (trousers folds,
pockets, seams, dificult areas to reach), much
easier and avoids the false ceases that seam
crushing can produce.
• For continuous suction function set the selector
switch on position “I”.
• For continuous blowing function set the
selector switch on position “II”.
• With the switch in position “0” suction and
blowing functions are switched off.
Selector switch
Important: Do not rest the warm iron directly on
the iron storage shelf, always use the iron rest
mat included.
after ironing
• Leave the board on for 10 minutes to dry the
cover and remove any possible condensed
water from the board.
• Turn off the ironing board using the power
on/off switch.
• Remove the plug from the socket.
• let the equipment cool completely.
• Remove the iron cord support.
• Place the iron on the iron rest pad.
• Unplug the iron/steam generator from the
auxillary socket and remove it from the board.
• Fold the shelf back over the ironing surface.
• Wind the power supply cord on to the cord
winder lugs beneath the board.
• Hold the board leg with your foot to stop it skidding.
• Operate the height adjustment lever and close
the board.
Note: do not entangle the power cord.
• Store the closed board in a vertical position
with the folded shelf end towards the loor.
• Always ensure that the board does not skid and
tilt. Store the equipment in a dry place and out
of reach of the children.
maintenance
Changing the cover
For safety reasons (heated board surface) and to
guarantee a perfect operation of the product we
recommend that you use only Siemens ironing
board covers.
Metalised heat relective covers and covers with
thick lining are not suitable for this equipment and
may cause overheating of the suction motor.
Original covers and other accessories are available
from authorised technical service centres.
Accessory code
(After-sales)
576007
Warning:
In case of failure, of faulty equipment or if damage
due to falling over is suspected, immediately
remove the plug from the socket. Repairs should
be exclusively per-formed at the authorised
Service Centre. Repairs performed by unskilled
personnel may cause serious dangers for users.
Responsibility is declined for damages caused by
repairs performed by unskilled personnel. In these
cases the warranty right is also cancelled.
advice on disposal
Our goods come in optimised packaging. This
basically consists in using non-contaminating
materials which should be handed over to the local
waste disposal service as secondary raw materials.
Your local town council can give you information
about how to dispose of obsolete appliances.
This appliance is labelled in
accordance with European Directive
2012/19/EU concerning used
electrical and electronic appliances
(waste electrical and electronic
equipment - WEEE).
The guideline determines the framework for
the return and recycling of used appliances
as applicable throughout the EU.
You can download this manual from the local homepages of Siemens.