Matrix Orbital VFD2041 Legacy - Manual (Page 16)

VFD2041 rev 2 16
3.4.7 Turn on block (blinking) cursor (254 83)
Turns on the blinking block cursor. The cursor shows the current text insertion point. The block cursor is
ON by default.
3.4.8 Turn off block (blinking) cursor (254 84)
Turns off the blinking block cursor.
3.4.9 Cursor left (254 76)
Moves the cursor one position to the left but does not erase any character that may be in that position. Note
that this command moves the text insertion point even if the cursor is turned off.
Note: A "destructive backspace", which erases the character to the left of the original position, may be done
by issuing the following sequence: cursor left, space, cursor left.
3.4.10 Cursor right (254 77)
Moves the cursor one position to the right but does not erase any character that may be in that position.
Note that this command moves the text insertion point even if the cursor is turned off.