Matrix Orbital LK162-12 Legacy - Manual (Page 29)

LK162-12 rev 4 29
6.1.12 Set I
2
C address 254 51 [address])
This command sets the I²C write address of the module. This value must be an even number and the read
address is one higher. For example if the I²C write address is set to 0x50, then the read address is 0x51. The
change in address is immediate. This address is 0x50 by default, and is reset temporarily back to that value
when the "Manual Over-ride" jumper is used on power up.