ASKO W6903 - Manual (Page 34)

Read these instructions carefully and com-
pletely before you install the machine. The
installation should be carried out by a qualified
person who is familiar with all local codes and
ordinances for electrical and plumbing con-
nections.
Cosmetic damage must be reported to your
dealer within five days from the date of pur-
chase. After unpacking the washer, thorough-
ly check the unit for cosmetic damage.
Leveling the machine
It is important that the machine is level to
prevent excessive vibrations during spin cy-
cles. Each foot of the washer is adjustable,
so you can level the washer on any surface.
Once it is level, securely tighten the lock nuts
on the feet to prevent excessive vibration
during spin cycles.
Be sure to tighten the
lock nuts securely when
you level the machine.
Water supply connection
Since ASKO washers have a built-in heating
element, you only need a cold water inlet. The
connection should be made by someone who
is sufficiently skilled. Use the hose supplied
with the washer. (The inlet hose is marked for
correct connection.) The water pressure must
be in the range 15–146 PSI. A tap should be
fitted on the water supply pipe. If a new supply
pipe has been installed for the washer, it
should be flushed thoroughly to remove any
foreign particles that might clog the filter in
the water inlet.
Note!
If the unit is installed on a second storey, fol-
low local building codes. We recommend in-
stalling a drip pan.
Customer Care Center 34
1-800-898-1879
www.askousa.com
Installation instructions