Clary SP1250 LE - Manual (Page 12)

Page 12
USB SETUP
1. Contact Clary Corporation or your representative for latest software version.
o
SP560/SP1250LE Software
o
CDC_PCDriver
2. Connect the USB cable from your computer to the UPS’s USB port (use the USB type B
(Square) port).
3. Turn on the UPS.
4. Your computer will need a driver to connect for the first time. You should get a prompt as
follows: Click on “No, not at this time” then “Next”.
5. Select the “Install from a list or specific location” then click “Next”