Waterloo F1878 - Manual (Page 2)

Hardware bag
Caster Pack
Literature
TO ATTACH CHEST
Process:
· Remove enough drawers to access the top and bottom
mounting surfaces of the units. Refer to drawer removal
instructions.
· Place the chest in the desired location on top of the cabi-
net or intermediate chest and mark the mounting hole
locations onto the cabinet top.
· Remove the chest and drill two 5/16" (8mm) holes
through the top of the cabinet or intermediate chest.
· Secure the units together using two 1/4 - 20 x 5/8"
screws and nuts at each joint. The hardware is provided
in the bag located in the top tray of the chest.
Tools Required:
3/8 inch wrench Screwdriver
7/16-in wrench 5/16-inch drill bit
CHEST HARDWARE INCLUDED:
NOTE: Not all assembly instructions will apply to your
model.
Process:
• Remove bottom drawers. (See Operation Section, Part
B.)
• Lay the cabinet on its back. Use packaging material to
protect the finish.
• Mount both swivel casters on the same side of the unit
as the side handle.
• Attach the casters using (4) 1/4 - 20 x 5/8" screws and
(4) 1/4 - 20 nuts per caster.
• Wrench tighten all screws. It is recommended not to
exceed 80 inch pounds of torque.
• Return the unit to its upright position.
• Reinstall bottom drawers.
CASTER INSTALLATION
Items Needed:
1/4 - 20 x 5/8" Screw (Qty: 16)
1/4 - 20 Nut (Qty: 16)
7/16-in Wrench
3/8-in Wrench
INTERMEDIATE CHEST HARDWARE INCLUDED:
1/4 - 20 Nut (Qty: 4)
1/4 - 20 x 5/8" Screw (Qty: 4)
CABINET HARDWARE INCLUDED:
1/4 - 20 Nut (Qty: 16)
1/4 - 20 x 5/8" Screw (Qty: 16)
WARNING
Remove wooden work surface or rubber mat, if any,
before attaching chest(s) to the cabinet.
2
HARDWARE CARTON CONTENTS
ASSEMBLY
1/4 - 20 Nut (Qty: 4)
1/4 - 20 x 5/8" Screw (Qty: 4)
Screw
Nut