On the Edge Marketing DRINK BLENDER - Manual (Page 5)

Screw
Kill button
B
C
tight and secure fit.
C. WARNING: ALWAYS USE PRE-MIXED GAS ONLY!
D. Mix 50 part gasoline to 1 part 2-cycle oil in a gas container SHAKE
WELL and pour into fuel tank.
E. Your “Drink Blender” uses a standard 2-stroke motor so always use
unleaded gasoline.
F. Never fill your “Drink Blender” with fuel while motor is running, and
never overfill it!! Use caution when handling fuel. Move “Drink
Blender” away from fuel source before starting the engine.
G. Keep children, bystanders and pets out of the operating area.
H. Keep all parts of your body away from all moving parts when engine
is running.
4. Operating Instructions
A. Close the choke.
B. On the bottom of the carburetor, there is primer ball, press it until its
firm, then your “Drink Blender” should be ready to start!
C. Pull the pull-handle two or three times until your “Drink Blender” starts.
D. Close the choke valve, and it should be ready for action.
For a safety precaution, there is a red kill-button next to the twist grip.
5. General Maintenance
A. Check fuel level and all bolts & nuts, tighten if necessary. Check fuel
lines for any leakage and ALWAYS USE PRE-MIXED 50:1 FUEL.
B. Let your “Drink Blender” warm-up 3-5 minutes before use. Keep
handles dry, clean, and free of oil or fuel mixture.
C. Breaking-in the engine is important. DO NOT run full throttle within the
first 20 hours of use.
D. Please use fuel in accordance with the 50:1 ratio as described earlier.
E. If Engine malfunctions, DO NOT OPERATE, Contact 866.438.6836.
Service should be performed by qualified personnel.
B. Insert the handlebars, line up the screw
holes and insert the screws supplied
and fasten them down firmly.
Periodically check screws to maintain
a tight fit. Screws may loosen due to
vibration (see image B).
C. Your “Drink Blender” has a safety kill button in
case of an emergency (see image C).
D. Your “Drink Blender” uses 2-stroke oil and
unleaded gas ONLY. Mixing Ratio: 25:1
(for 1 st 50 uses) and then switch to 50:1
E. Only operate your “Drink Blender” in well ventilated areas. Exhaust
from the engine contains harmful ingredients and any long term
exposure should be avoided.
F. Your “Drink Blender” is designed for use by ADULTS ONLY. DO NOT
operate when tired, ill or under the influence of alcohol, drugs or
medication.
G. Never leave your “Drink Blender” running or unattended.
H. Whenever using the “Drink Blender”, please be sure the unit is
located on secure, flat, and even surface before operating.
I. Please DO NOT touch the engine until the motor has stopped for at
least 10 - 15 minutes, as some parts of engine remain hot. This is to
protect from burns and heat damage.
J. Keep your “Drink Blender” away from heat or direct flames.
K. DO NOT fill your pitcher more than 3/4 full and securely hold the
pitcher and lid while operating.
3. Before Using Your Drink Blender
A. Always inspect and clean your “Drink Blender” pitcher and blades
before use.
B. Always inspect the nuts and bolts of your “Drink Blender” to ensure a
3 4