On the Edge Marketing DRINK BLENDER - Manual (Page 3)

6. Trouble Shooting
For hard start-up failure:
A. Check if fuel line is good.
B. Make sure the safety stop bottom is working smoothly.
C. Check to see if there is some air in the fuel line. If so, please press
or pump the primer ball until the fuel line is clean of any air bubble.
D. Check to see if the choke is open.
E. Check to see if the air and fuel is normal.
F. Make sure air filter is not clogged.
G. Please check to make sure air vent, muffler or fuel line are not
clogged and are functioning properly.
7. Motor Specifications
5 2
Item
Engine
Bore x Stroke
Spark plug
Carburetor
Speed idling
Turn way of engine output
Spark plug gap
Fire mode
Start mode
Fuel
Output
Scheduled power
Clutch type
Fuel consumption
Fuel tank volume
Parameter
Single cylinder, air-cooling 2 stroke
40mm x 34mm
BM6A
Double film
2700± 200rpm
Counterclockwise
0.6 - 0.7mm
PBI
Manual start-up
Unleaded gasoline: 2-stroke engine oil = 50:1
43cc
1.2kW @ 6500rpm
Centrifugal
610g / kW. h
0.72 qt
Warning! Read and follow all safety precautions in the
operator’s manual. Failure to follow these instructions
could result in serious injury.
1. Parts List and Specifications
A. Parts List
(1) Stainless steel drink pitcher with lid
(2) Handlebar / Twist grip (twist grip attached to main frame via
throttle cable)
(1) Main frame with engine
(2) Handlebar screws (may be attached to handle bar)
(1) Gas/2-stroke oil mixing bottle
(1) Spark plug wrench
B. General Technical Statistics:
Length (in): 13
Width (in): 24.4 with handlebars
13 without handlebars
Height (in): 24.8
Maximum pitcher capacity: 2.5 qt
C. Engine Picture
2. Warnings
A. Once the handlebars are safely assembled and attached, it is OK to
lift and transport the “Drink Blender” using the handlebars.