MagTek JMTMacMS Applet User Manual
Jmtmacms applet for magtek hid card reader mac osx, Programmer’s guide, Confidential

JMTMacMS Applet for
MagTek HID Card Reader
Mac OSX
PROGRAMMER’S GUIDE
PART NUMBER 99875456-1
NOVEMBER 2009
Confidential
This document contains the proprietary information of MagTek. Its receipt or
possession does not convey any rights to reproduce or disclose its contents or to
manufacture, use or sell anything it may describe. Reproduction, disclosure or use
without specific written authorization of MagTek is strictly forbidden.
Unpublished – All Rights Reserved
REGISTERED TO ISO 9001:2000
1710 Apollo Court
Seal Beach, CA 90740
Phone: (562) 546-6400
FAX: (562) 546-6301
Technical Support: (651) 415-6800
www.magtek.com
Table of contents
Document Outline
- I. Introduction
- II. System Requirements
- III. Software Requirements
- IV. JMTMacMS Component Requirements
- V. JavaScript API functions
- SetCardData(value)
- SetCardDataMsk(value)
- SetPAN(value)
- SetFirstName(value)
- SetLastName(value)
- SetMonth(value)
- SetYear(value)
- SetTrack1Len(value)
- SetTrack2Len(value)
- SetTrack3Len(value)
- SetTrack1MskLen(value)
- SetTrack2MskLen(value)
- SetTrack3MskLen(value)
- SetTrk1Encrypted(value)
- SetTrk2Encrypted(value)
- SetTrk3Encrypted(value)
- SetTrack1MskData(value)
- SetTrack2MskData(value)
- SetTrack3MskData(value)
- SetMPStatus(value)
- SetMPData(value)
- SetMPLen(value)
- SetDeviceSN(value)
- SetReaderID(value)
- SetEncodeType(value)
- SetDUKPTKSN(value)
- SetSessionID (value)
- SetCRStatus(value)
- SetResults(value)
- SendStrCmd()
- SetAllCardData(value)
- SetCardReadingError()
- ReportJavaPluginVersion()
- DeviceReady()
- GetTrack1DecodeStatus()
- GetTrack2DecodeStatus()
- GetTrack3DecodeStatus()