MagTek 90-MILLIMETER SWIPE READER - Manual (Page 9)

3
SECTION 2. INSTALLATION
This section consists of installation and connection of the Reader.
MOUNTING
The dimensions for mounting are shown in Appendix A.
CONNECTORS
The connector pin lists are shown below. Connector J2 is provided for easy access without
removing the PC board. If additional strain relief is required, J3 may be used, and a tie wrap can
be routed through the holes adjacent to J3 to secure the cable.
The mating connector is:
Housing Molex PN# 51021-0400
Terminal Molex PN# 50058-8000, 4 required.
I/O signal pin list is shown in Table 2-1.
Table 2-1. 2-Track and 3-Track I/O Signals
PCB J2 and J3 Signal
1 V
DD
2 GND
3 SO Data
4 SO Strobe
INTERFACE
For interface requirements refer to Triple Track ASIC with Shift-Out 3V, Specifications, P/N
99875337.