Martin Sprocket & Gear MST Idler Bushings User Manual
Martin, Mst idler bushing mounting instructions, Installation

INSTALLATION:
1. Make sure that the shoulder bolt
will fit into the mounting bracket.
2. Remove the outer jam nut.
3. Make sure the inner jam nut
is properly torqued (see Table A)
4. Prior to assembly of idler product onto bushing, make sure bushing barrel
and product bore are free of contaminants (such as paints or oils) and no
burrs exist.
Do NOT use lubricants or anti seize material
on bushing barrel, hub or threaded surfaces.
5. Align mounting holes, insert cap screws and loosely thread them into the
idler product.
�
�������
�
�������
����������������������������������������
�������������������������������������������
�����������������������
�����������������������������������
�������������������������������
�
�������
�������������������������������������
�������������������������������������
������������������������������������
��������������������
�
�������
�
�������
����������������������������������������
�������������������������������������������
�����������������������
�����������������������������������
�������������������������������
�
�������
�������������������������������������
�������������������������������������
������������������������������������
��������������������
�
�������
���������������������������������
�����������������������������������
�������������������
�
�������
��������������������������������������
Martin
MST IDLER BUSHING
MOUNTING INSTRUCTIONS
TABLE A
Idler
SAE Grade 5
Mounting Bracket Tightening Torque
Bushing Shoulder Bolt Size Thread Depth (min) lb-in
N-m
H-BB 1/2
1/2-13NC
.77”
300
33.9
P1-BB 5/8
5/8-11NC
1.00”
350
39.5
Q1-BB 3/4
3/4-10NC
.923”
550
62.1
Q1-BB 1
1-8NC
1.08”
800
90.3
Mounting_Bushings.indd
4/16/03, 12:20 PM
2