Teledex CL Series - Manual (Page 4)

C HARGING THE B ATTERY
The rechargeable Nickel Metal Hydride battery must be fully char ged before using the
phone for the first time. It is recommended that the battery pack be char ged overnight
(or for at least 12 hours) without interruption before the first use. To charge the battery,
place the handset, keypad down, in the base unit. Ensure that the “CHARGE” LED on the
base illuminates. If the LED does not light, check the following:
a) Ensure that the AC adapter is plugged into a working unswitched AC outlet.
b) Ensure that the contacts on the bottom of the handset bottom are making good contact
with the base unit charging contacts.
C LEANING THE B ATTERY C ONTACTS
To maintain the handset in fully-charged condition, it is important to clean all char ging con-
tacts on the handset and base unit. Use a pencil eraser or other contact cleaner . Do not use
any liquids or solvents to clean these contacts.
A DJUSTING THE B ASE R ING V OLUME
To adjust the ringer volume of the base unit, locate the respective “Line Ringing Volume”
adjustment control on the back of the telephone labeled “RINGER LOW/HI.” Slide the
switch to the desired setting.
A DJUSTING THE H ANDSET R ING V OLUME
The handset ring volume can be adjusted by pressing the volume “UP” and “DOWN” keys
on the handset during the ringing or idle mode.
A DJUSTING S PEAKERPHONE V OLUME
To adjust the speakerphone volume, press the volume “UP” and “DOWN” keys on the base
unit. Press volume “UP” key to increase the volume level. Press the volume “DOWN” key
to decrease volume level.
A DJUSTING H ANDSET R ECEIVE V OLUME
To adjust the handset receiver volume, press volume “UP” and “DOWN” keys on the hand-
set while the handset is on line. Volume control is also available during mute.
L IGHTED K EYPADS
The keypad on the handset will illuminate if one of the keys is pressed. It will turn of f after
a few seconds. If the “ON” key is pressed, the keypad will illuminate and then go of f after
a few seconds, except the “ON” key. This is to indicate that the phone handset is on. The
light will turn off when the “OFF” key is pressed.
L OW B ATTERY I NDICATOR
When the handset battery level is low, the LED indicator will blink when the phone is not
in use. When the phone is in use, the LED will blink and the handset will emit a beep tone.
Return the handset to the base cradle for rechar ging as soon as is practical.
2