Kenwood SW-40HT-BK - Manual (Page 5)

SW-40HT B61-1290-00 0
ENGLISH
5
Installation
Howling
If the Subwoofer is installed near an analog record turntable, a
howling sound may be generated. If this occurs, place the
Subwoofer farther away from the turntable or reduce the
Subwoofer volume (By rotating the VOLUME control
counterclock-wise). The howling phenomenon may also occur
due to cross interference with a cassette deck, compact disc
player, or Laserdisc player, although this is very rare. If sound
or picture seems to be distorted due to this reason, place the
Subwoofer farther away from other components or reduce its
volume.
Operation near a TV
If the Subwoofer is installed near a TV set, the TV reception
may be affected and interfered with color irregularities. Should
color irregularities observed on TV screen, separate the
Subwoofer from the TV until its reception becomes normal.
Connections
If your amplifier or receiver outputs only the L/R separated,
line-level signals, it is required to use an adapter for synthesiz-
ing the L and R signals (not provided) in order to connect the
Subwoofer to such an amplifier or receiver.
÷ In case an associated system component is connected,
also read the instruction manual of the component.
÷ Be sure to insert all connection cords securely. If their
connections are imperfect, the sound may not be pro-
duced or noise may interfere.
SUB SUB WOOFER WOOFER
PRE OUT PRE OUT
LINE INPUT
Amplifier or Audio Video control center
Pin-plug cord
CAUTION
Simply setting the POWER switch to OFF does not shut
down the power supplied to the unit completely. To
isolate this unit completely from the power supply, it
is necessary to unplug the power cord from the power
outlet.
To shut down the power supply to the unit immedi-
ately in case of an emergency, connect the power plug
to an easily accessible power outlet.
CONNECTION PRECAUTIONS
Do not connect the power cord plug into the power
outlet until all other connections are complete.
Before unplugging a cord or cable from the unit, be
always sure to set the POWER switch to OFF and un-
plug the power plug from the power outlet.
Power plug
To AC wall outlet
Insert the power plug all the
way and securely into a
power outlet.